You'll need to read some info off of their ont and then spoof the sfp+ adapter's mac address along with some other software labels.ĭslreports' forums is probably the best place get some basic info while active work and help is best gotten from their discord. But from what I understand there is little or no authentication if you bypass their ont. You'll need to get a programmable sfp+ fiber thingy and a device with an sfp+ port. It required some 802.1x wired authentication and some "easy" to acquire certificates for said authentication.īut newer setups with the gateway with the internal ont require a different method. Older setups with the external ont could dump the gateway and connect with their ethernet. You have the newer setup with a gateway that has an integrated ont. How likely are you to swap out that gateway? It's not easy and officially you can't but it's doable and has been done. Now I'm sorta hoping I can eke out a little more performance if I upgrade to a dual 2.5G router. After disabling that, I am getting a full 936 Mbps up and down-the limit of what you can expect over 1 Gbps networking: Update: After investigating the slow speeds a bit, I found out I had enabled QoS for bandwidth limiting on my guest network at some point-that resulted in my poor ASUS RT-AX86U processing so many packets the CPU would overload full-tilt, leading to lower overall performance (even on the main wired Ethernet network). If you have any additional ideas or experience with self-hosting behind AT&T Fiber, let me know! I'm just happy to be paying half as much as I was for Charter/Spectrum coax, but getting more than 20x faster upload speeds :) My Raspberry Pi running Wireguard / PiVPN now gives me about 300 Mbps up and down (was previously limited to 35 Mbps up and down due to the slow upload speed on Spectrum!).Will continue monitoring my Internet connection with my Raspberry Pi to see if that changes over time. Currently I'm only measuring 550 Mbps down and 650 Mbps up, tested via 10 Gbps internal LAN and WiFi 6E network right next to my AP.I was paying $135/month for 1 Gbps down, 40 Mbps up with Spectrum.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |